PDA

JOIN THE FORUM LOUNGE!

By Joining The Forum Lounge you will be able to see the pictures in this thread and post a reply. Also, after 25 posts you'll be able to see the hidden forums as well!

It's free and all of your information is confidential.

Click here to begin interacting!
Click here to register

Join in on this Discussion and see the pictures. Click here-> : fun nhra dragster facts


Texas89LX
06-13-2002, 01:56 PM
* One dragster's 500-inch Hemi makes more horsepower than the first 8 rows at Daytona.
* Under full throttle, a dragster engine consumes 1 1/2 gallons of nitro per second, the same rate of fuel consumption as a fully loaded 747 but with 4 times the energy release per volume.
* The supercharger takes more power to drive then a stock hemi makes.
* With nearly 3000 CFM of air being rammed in by the supercharger on overdrive, the fuel mixture is compressed into nearly-solid form before ignition. Cylinders run on the verge of hydraulic lock.
* Dual magnetos apply 44 amps to each spark plug. This is equivalent to the output of an arc welder in each cylinder.
* At stoichiometric (exact) 1.7:1 air/fuel mixture (for nitro), the flame front of nitro methane measures 7050 degrees F.
* Nitro methane burns yellow. The spectacular white flame seen above the stacks at night is burning hydrogen, dissociated from atmospheric water vapor by the searing exhaust gases.
* Spark plug electrodes are totally consumed during a pass. After 1/2 way, the engine is dieseling from compression-plus the glow of exhaust valves at 1400 degrees F. The engine can only be shut down by cutting of it's fuel flow.
* If spark momentarily fails early in the run, unburned nitro builds up in those cylinders and then explodes with a force that can blow cylinder heads off the block in pieces or blow the block in half.
* Dragsters twist the crank (torsionally) so far (20 degrees in the big end of the track) that sometimes cam lobes are ground offset from front to rear to re-phase the valve timing somewhere closer to synchronization with the pistons.
* To exceed 300 mph in 4.5 seconds dragsters must accelerate at an average of over 4G's. But in reaching 200 mph well before 1/2 track, launch acceleration is closer to 8G's.
* Drivers shut off before the finish line, or even dual parachutes will not stop the car.
* If all the equipment is paid off, the crew worked for free, and for once NOTHING BLOWS UP, each run costs $1000.00 per second.
* Dragsters reach over 300 miles per hour before you have read this sentence.

VeilSideTwinT
06-13-2002, 02:46 PM
Another interesting NHRA fact: &nbsp;My dad works on the superchargers for Amato Racings Bilstien Engine Flush dragster <img src="http://www.spartanburgracing.com/cgi-bin/ikonboard/iB_html/non-cgi/emoticons/smile.gif" border="0" valign="absmiddle" alt=':)'>. &nbsp;They won for the first time this season like two weeks ago in Topeka. I think it was topeka...anyway....

Ill post a pic of a piston that he gave me that was blown by the 6,000 hp beast he works on later.

peace
james

Texas89LX
06-14-2002, 12:42 AM
some corrections and new stuff
couple are certainly BS - but good read nonetheless

* Dragsters twist the crank (torsionally) so far (20 degrees in the big end of the track) that sometimes cam lobes are ground offset from front to rear to re-phase the valve timing somewhere closer to synchronization with the pistons.

BUZZZZZ - then how do they sometimes not change the shortblock or he engine between rounds? 20* that's nuts. I wouldn't doubt that there is some twist to the crank, but nothig like that.

* Drivers shut off before the finish line, or even dual parachutes will not stop the car.

BUZZZZZ - watch a video tape - they cross the finish line under power. 1/2 mile long shutdown is plenty long to stop the car with the chutes. I've seen them stop in that distance on brakes alone, but I guantee they didn't want to.

* Spark plug electrodes are totally consumed during a pass. After 1/2 way, the engine is dieseling from compression-plus the glow of exhaust valves at 1400 degrees F. The engine can only be shut down by cutting of it's fuel flow.

BUZZZZZ - while the plugs are basically toast after a run, there is still electrode - there is a lot of technology in those little boogers. Ever see them readig plugs after a pass - I have. If a Top Fuel engine diesels, it goes boom when under WOT. they are generally shut down by killing fuel - but that is also due in part to the magnetos.

The flame above the headers is fuel lighting. They run so much fuel through them that some is unburnt and lights in the headers.

If spark goes out, the engine just pumps fuel out, it doesn't go boom.

I'm questioning the blower drive power one. You can turn them over by hand off of the engine. I'm sure they take a lot of hp to turn at speed, but 425?? Seems high to me.

Some other neat ones. If you have a rocker failure, the boost that normally goes into that cylinder goes into the others. Since they are getting more air, they go lean and then you lift the heads. That is usually a big fireball.

The only computers on the car are for data acquisition. Everything is controlled with CO2 operated timers.

06-14-2002, 12:24 PM
that was sweet <img src="http://www.spartanburgracing.com/cgi-bin/ikonboard/iB_html/non-cgi/emoticons/biggrin.gif" border="0" valign="absmiddle" alt=':D'>

Stegall
06-25-2002, 09:25 PM
Another nhra fact

0-100 mph in less then a seccond.

Drives experince a great G force range then astronauts * do... * 0 to 6 Gs on launch 6 to -7 Gs when they pop open the parachuts

they use over 4 gallons of nitro for the burn out.



also, I had the chance to see a Jet powered drager up in bristol this weekend,...

very very cool

<img src="http://www.spartanburgracing.com/cgi-bin/ikonboard/iB_html/non-cgi/emoticons/biggrin.gif" border="0" valign="absmiddle" alt=':D'>

JOIN THE FORUM LOUNGE!

By Joining The Forum Lounge you will be able to see the pictures in this thread and post a reply. Also, after 25 posts you'll be able to see the hidden forums as well!

It's free and all of your information is confidential.

Click here to begin interacting!
Click here to register