Toxico
07-22-2005, 09:53 AM
I actualy tried it the right way first, with an 8mm pin punch, but all that did was flatten out the pin. Any ideas how to remove one other than drilling it out?
| JOIN THE FORUM LOUNGE! By Joining The Forum Lounge you will be able to see the pictures in this thread and post a reply. Also, after 25 posts you'll be able to see the hidden forums as well! It's free and all of your information is confidential. |
Join in on this Discussion and see the pictures. Click here-> : removing roll pins
Toxico 07-22-2005, 09:53 AM I actualy tried it the right way first, with an 8mm pin punch, but all that did was flatten out the pin. Any ideas how to remove one other than drilling it out? Cosby 07-22-2005, 11:31 AM The tranny roll pins? I've always used a punch and a big mallet. A regular hammer won't do the trick for some reason. You barely have to tap it with the mallet and it will slowly move out. The initial hit is the hardest, once you get it below that edge into the hole it's easy as hell. rxtasy 07-22-2005, 12:54 PM punches work for me. i've even used a center punch to get it below the surface first. |
| JOIN THE FORUM LOUNGE! By Joining The Forum Lounge you will be able to see the pictures in this thread and post a reply. Also, after 25 posts you'll be able to see the hidden forums as well! It's free and all of your information is confidential. |